TR-3B PROCEDURES

TR-3B PROCEDURES

For detailed instructions on how to fly this aircraft, see the Flight Manual in the TR-3B Aircraft Folder. For suggested speeds, see the Reference page of the Kneeboard.

Visual Properties

To... Press...

Display/hide tug truck
(or drag chute on Aircraft 301) Wing Fold command

Open weapon bay Shift+E

Rotate fuel receptacle Shift+E then press 2

Panel Controls

To... Press...

Display/hide Throttle SHIFT+2

Display/hide GPS SHIFT+3

Display/hide radio
(MFD2 screen 2) SHIFT+4

Display/hide RMI
(MFD3 screen 2) SHIFT+5

Display/hide fuel monitor
(MFD3 screen 3) SHIFT+6

PUSHBACK (if parked at a gate)

[ ] Pushback

REQUEST
(press SHIFT+P, then 1 for tail-left or 2 for tail-right, then press SHIFT+P to stop)
Use Wing Fold command bring up a Tug.

BEFORE START

[ ] Parking Brake SET
(press CTRL+PERIOD key)

ENGINE START

Press CTRL+E to initiate engine autostart sequence.

AFTER START

[ ] Engine Start Switches CHECK GEN

[ ] Pitot Heat ON

[ ] De-ice AS REQUIRED

[ ] Engine Start Levers CHECK IDLE

[ ] Lights AS REQUIRED

[ ] Autopilot SET and OFF

[ ] Instruments CHECKED

[ ] Autobrake Switch RTO (Rejected Takeoff)
(press SHIFT+2 to display throttle quadrant)

[ ] Avionics Switch ON

[ ] Avionics SET
(press SHIFT+4 to display Nav-Com screen)

DURING TAXI/BEFORE TAKEOFF

[ ] Brakes RELEASE
(press PERIOD key)

[ ] Thrust Levers INCREASE SLIGHTLY TO ROLL
(press F3 or F2 as necessary)

[ ] Thrust Levers IDLE FOR TAXI
(press F2 or F3 as necessary)

[ ] Flight Controls CHECK

[ ] Flaps SET FOR TAKEOFF
(0-5 for normal)
(15 for short field)
(press F7 as necessary)

[ ] Brakes SET
(press PERIOD key)

[ ] Pitch Trim Set to 7

CLEARED FOR TAKEOFF

[ ] Engine Start Switches GEN

[ ] Flight Director ON

[ ] Autothrottle ARM

[ ] Transponder ON
(press SHIFT+4 to display Nav-Com screen)

[ ] Lights AS REQUIRED

TAKEOFF

[ ] Brakes RELEASE
(press PERIOD key)

[ ] Thrust Levers ADVANCE SMOOTHLY TO 40% N1
(press F2 or F3 as necessary)

--WAIT FOR ENGINE STABILIZATION--

[ ] Thrust Levers ADVANCE SMOOTHLY TO 100% N1
(press F2 or F3 as necessary)

--or--

[ ] TO/GA Mode ENGAGE
(press CTRL+SHIFT+R)

[ ] Engine Instruments MONITOR

[ ] Airspeed 80 KIAS CALLOUT "80 KNOTS"

-- VERIFY PROPER THRUST SET--

[ ] Airspeed V1 123Kias CALLOUT "V1"

[ ] Airspeed VR 135Kias CALLOUT "ROTATE"

--ROTATE TO APPROX. 10 DEGREES PITCH UP--

[ ] Airspeed V2 145Kias CALLOUT "V2"

[ ] Landing Gear UP (WHEN POSITIVE CLIMB ESTABLISHED)
(press G)

[ ] Airspeed MAINTAIN V2+20 KIAS

[ ] Autopilot ENGAGE AT 1,000' AGL

[ ] Flaps RETRACT TO 1 AT 1,000' AGL
(press F6 until 1)

[ ] Flaps UP AT 210 KIAS
(press F6 until Up)

[ ] Autothrottle OFF

[ ] Thrust Levers 90% N1
(press F2 or F3 as necessary)

[ ] Airspeed 250 KIAS AT 3,000' AGL

[ ] Landing Gear Lever Verify OFF

CLIMB

[ ] Airspeed MAINTAIN 250 KIAS

[ ] Landing Lights OFF ABOVE 10,000' MSL

[ ] Airspeed 350 Kias above 10,000'MSL

[ ] Altimeter SET TO 29.92 CROSSING 18,000' MSL

CRUISE

(0.65 Mach @ 41,000 for best cruise)

[ ] Thrust Levers AS DESIRED
(press F2 or F3 as necessary)

[ ] Trim AS NECESSARY
(press Num Pad 1 or Num Pad 7 as necessary)

DESCENT

[ ] Autobrake Switch AS DESIRED

[ ] Airspeeds (VREF, VAPP) COMPUTED and SET
(see the Reference page of the Kneeboard)

[ ] De-ice AS REQUIRED

[ ] Autopilot AS DESIRED

[ ] Thrust Levers AS DESIRED
(press F2 or F3 as necessary)

[ ] Altimeter SET TO LOCAL SETTING CROSSING 18,000' MSL

[ ] Avionics SET

[ ] Airspeed <250 KIAS BELOW 10,000' MSL

[ ] Landing Lights ON BELOW 10,000' MSL

[ ] Approach Procedure REVIEW

APPROACH

[ ] Airspeed AS DESIRED

[ ] Thrust Levers AS DESIRED
(press F2 or F3 as necessary)

[ ] Flaps AS DESIRED
(press F7 as necessary)

[ ] Autopilot AS DESIRED

[ ] Autothrottle ARM

LANDING

[ ] Airspeed AS DESIRED

[ ] Thrust Levers AS DESIRED
(press F2 or F3 as necessary)

[ ] Landing Gear DOWN AND CONFIRMED
(press G)

[ ] Flaps AS DESIRED
(press F7 as necessary)

[ ] Start Switches GEN

[ ] Autopilot AS DESIRED

LANDING ROLL

[ ] Thrust Levers IDLE
(press F2 or F3 as necessary)

[ ] Autopilot CHECK DISENGAGED

[ ] Autothrottle CHECK OFF

[ ] Speedbrake Lever CHECK FULL DEPLOY

[ ] Brake AS NECESSARY
(press PERIOD key)

[ ] Thrust Levers IDLE AT 30 KIAS
(press F3 until Idle)

TAXI-IN

[ ] Speedbrake Lever DN
(press / [FORWARD SLASH key])

[ ] Flap Lever FULL UP
(press F5)

[ ] Pitot Heat OFF

[ ] Engine Start Switches AS DESIRED

[ ] Landing Lights AS DESIRED

[ ] Flight Director OFF

[ ] Transponder AS REQUIRED

PARKING

[ ] Parking Brake SET
(press CTRL+PERIOD)

[ ] Start Levers CUTOFF
(press CTRL+SHIFT+F1)

[ ] De-ice OFF

[ ] Lights AS REQUIRED

[ ] Transponder AS REQUIRED

To...	Press...
Display/hide tug truck (or drag chute on Aircraft 301)	Wing Fold command
Open weapon bay	Shift+E
Rotate fuel receptacle	Shift+E then press 2

To...	Press...
Display/hide Throttle	SHIFT+2
Display/hide GPS	SHIFT+3
Display/hide radio (MFD2 screen 2)	SHIFT+4
Display/hide RMI (MFD3 screen 2)	SHIFT+5
Display/hide fuel monitor (MFD3 screen 3)	SHIFT+6

PUSHBACK (if parked at a gate)

[ ] Pushback	REQUEST (press SHIFT+P, then 1 for tail-left or 2 for tail-right, then press SHIFT+P to stop) Use Wing Fold command bring up a Tug.

BEFORE START

[ ] Parking Brake	SET (press CTRL+PERIOD key)

ENGINE START

Press CTRL+E to initiate engine autostart sequence.

AFTER START

[ ] Engine Start Switches	CHECK GEN
[ ] Pitot Heat	ON
[ ] De-ice	AS REQUIRED
[ ] Engine Start Levers	CHECK IDLE
[ ] Lights	AS REQUIRED
[ ] Autopilot	SET and OFF
[ ] Instruments	CHECKED
[ ] Autobrake Switch	RTO (Rejected Takeoff) (press SHIFT+2 to display throttle quadrant)
[ ] Avionics Switch	ON
[ ] Avionics	SET (press SHIFT+4 to display Nav-Com screen)

DURING TAXI/BEFORE TAKEOFF

[ ] Brakes	RELEASE (press PERIOD key)
[ ] Thrust Levers	INCREASE SLIGHTLY TO ROLL (press F3 or F2 as necessary)
[ ] Thrust Levers	IDLE FOR TAXI (press F2 or F3 as necessary)
[ ] Flight Controls	CHECK
[ ] Flaps	SET FOR TAKEOFF (0-5 for normal) (15 for short field) (press F7 as necessary)
[ ] Brakes	SET (press PERIOD key)
[ ] Pitch Trim	Set to 7
CLEARED FOR TAKEOFF

[ ] Engine Start Switches	GEN
[ ] Flight Director	ON
[ ] Autothrottle	ARM
[ ] Transponder	ON (press SHIFT+4 to display Nav-Com screen)
[ ] Lights	AS REQUIRED

TAKEOFF

[ ] Brakes	RELEASE (press PERIOD key)
[ ] Thrust Levers	ADVANCE SMOOTHLY TO 40% N1 (press F2 or F3 as necessary)

--WAIT FOR ENGINE STABILIZATION--

[ ] Thrust Levers	ADVANCE SMOOTHLY TO 100% N1 (press F2 or F3 as necessary)
--or--
[ ] TO/GA Mode	ENGAGE (press CTRL+SHIFT+R)
[ ] Engine Instruments	MONITOR
[ ] Airspeed 80 KIAS	CALLOUT "80 KNOTS"

-- VERIFY PROPER THRUST SET--

[ ] Airspeed V1 123Kias	CALLOUT "V1"
[ ] Airspeed VR 135Kias	CALLOUT "ROTATE"

--ROTATE TO APPROX. 10 DEGREES PITCH UP--

[ ] Airspeed V2 145Kias	CALLOUT "V2"
[ ] Landing Gear	UP (WHEN POSITIVE CLIMB ESTABLISHED) (press G)
[ ] Airspeed	MAINTAIN V2+20 KIAS
[ ] Autopilot	ENGAGE AT 1,000' AGL
[ ] Flaps	RETRACT TO 1 AT 1,000' AGL (press F6 until 1)
[ ] Flaps	UP AT 210 KIAS (press F6 until Up)
[ ] Autothrottle	OFF
[ ] Thrust Levers	90% N1 (press F2 or F3 as necessary)
[ ] Airspeed	250 KIAS AT 3,000' AGL
[ ] Landing Gear Lever	Verify OFF

CLIMB

[ ] Airspeed	MAINTAIN 250 KIAS
[ ] Landing Lights	OFF ABOVE 10,000' MSL
[ ] Airspeed	350 Kias above 10,000'MSL
[ ] Altimeter	SET TO 29.92 CROSSING 18,000' MSL

CRUISE
	(0.65 Mach @ 41,000 for best cruise)
[ ] Thrust Levers	AS DESIRED (press F2 or F3 as necessary)
[ ] Trim	AS NECESSARY (press Num Pad 1 or Num Pad 7 as necessary)

DESCENT

[ ] Autobrake Switch	AS DESIRED
[ ] Airspeeds (VREF, VAPP)	COMPUTED and SET (see the Reference page of the Kneeboard)
[ ] De-ice	AS REQUIRED
[ ] Autopilot	AS DESIRED
[ ] Thrust Levers	AS DESIRED (press F2 or F3 as necessary)
[ ] Altimeter	SET TO LOCAL SETTING CROSSING 18,000' MSL
[ ] Avionics	SET
[ ] Airspeed	<250 KIAS BELOW 10,000' MSL
[ ] Landing Lights	ON BELOW 10,000' MSL
[ ] Approach Procedure	REVIEW
APPROACH

[ ] Airspeed	AS DESIRED
[ ] Thrust Levers	AS DESIRED (press F2 or F3 as necessary)
[ ] Flaps	AS DESIRED (press F7 as necessary)
[ ] Autopilot	AS DESIRED
[ ] Autothrottle	ARM

LANDING

[ ] Airspeed	AS DESIRED
[ ] Thrust Levers	AS DESIRED (press F2 or F3 as necessary)
[ ] Landing Gear	DOWN AND CONFIRMED (press G)
[ ] Flaps	AS DESIRED (press F7 as necessary)
[ ] Start Switches	GEN
[ ] Autopilot	AS DESIRED

LANDING ROLL

[ ] Thrust Levers	IDLE (press F2 or F3 as necessary)
[ ] Autopilot	CHECK DISENGAGED
[ ] Autothrottle	CHECK OFF
[ ] Speedbrake Lever	CHECK FULL DEPLOY
[ ] Brake	AS NECESSARY (press PERIOD key)
[ ] Thrust Levers	IDLE AT 30 KIAS (press F3 until Idle)

TAXI-IN

[ ] Speedbrake Lever	DN (press / [FORWARD SLASH key])
[ ] Flap Lever	FULL UP (press F5)
[ ] Pitot Heat	OFF
[ ] Engine Start Switches	AS DESIRED
[ ] Landing Lights	AS DESIRED
[ ] Flight Director	OFF
[ ] Transponder	AS REQUIRED

PARKING

[ ] Parking Brake	SET (press CTRL+PERIOD)
[ ] Start Levers	CUTOFF (press CTRL+SHIFT+F1)
[ ] De-ice	OFF
[ ] Lights	AS REQUIRED
[ ] Transponder	AS REQUIRED